Why choose MANTA M8P Board?

1. It is especially friendly to makers using Klipper. The all-in-one board is a motherboard with integrated

dual cores. One core can be installed with traditional 3D printer firmware (Marlin), while the other

core is installed on the core board and can run Klipper firmware

2. It is also very friendly for novice users who want to use Klipper for the first time. You can directly use the

motherboard to achieve the functions you want.

Introduction

MANTA M8P 2.0:Microprocessor:ARM Cortex-M7 STM32H723ZET6 550MHz

BIGTREETECH MANTA M8P motherboard is a 32-bit printer motherboard developed by Shenzhen Biqu Technology Co., Ltd. 3D printing team for Klipper firmware. Plug in the core board to run the Klipper firmware, which greatly simplifies the connection between the motherboard and the Raspberry Pi, and saves a lot of money. In the installation space in the chassis, the BTB seat is reserved on the motherboard, so that you can choose to use CM4 or other solutions.

1. Adopt 32-bit main frequency 64MHz ARM Cortex-M0 series STM32G0B1VET6 main control chip;

2. The power supply chip adopts TPS5450-5A, which supports DC12/24V power input. The output current of the

chip is up to 5A, and the peak value is up to 6A, which perfectly supports the power supply of Raspberry Pi;

3. The motherboard reserves the BOOT button, and users can update the motherboard boot program through DFU;

4. The 24V, 12V, and 5V voltages of the CNC fans are optional, eliminating the need for the customer to operate an external transformer module, thereby reducing the chance of damage to the motherboard;

5. The thermistor can select the pull-up resistance value through the jumper, in this way, it supports PT1000 without external module, which is convenient for customers to use DIY;

6. MCU firmware can be upgraded through SD card, or MCU firmware can be updated through DFU through Klipper's make flash command;

7. The main board and the core board use the BTB connection method, so that other core board solutions other than CM4 can be selected;

8. Support material break detection, shutdown, BLTouch, RGB lights and other functions

NOT IN THIS PACKAGE

CB1:CB1 is a computing core board similar to Raspberry Pi CM4.

1. CPU: Allwinner H616, Quad-core Cortex-A53 @1.5GHz

2. GPU: Mali G31 MP2, support OpenGL3.2

3. RAM: 512MB/1GB DDR3L SDRAM

4. Display: HDMI2.0A interface, support 4K display

5. USB 2.0 port

6. 100M Ethernet + 100M WiFi

7. The same BTB header as the Raspberry Pi CM4

Note:

1. The CB1 couldn't be connected to the PI TFT screen. The DSI/CSI port will only work while using CM4.

2. The PI4B should be used with CB1 or CM4 core board to run Klipper

3. No stepper drivers included to allow you to choose as needed..