Brand new aftermarket stator

Highest grade lamination materials

Highest grade copper windings resistant to 200 degrees celsius

All products shipped are tested

Battery condition is extremely important. No stator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced.

Brand new aftermarket stator

• You must re-install your original connector and grommet (see picture).
• Once your connector and grommet is re-installed, our part becomes a plug-and-play unit, direct fit, and very easy to install.
• Higher grade of electric components.
• Highest grade copper windings, resistant to 200 degrees Celsius.
• Back Plate included
• All products shipped are tested

All item pictures are accurate; if in doubt do not hesitate to compare our item to your original part.

Ski-doo Alpine II 503 Carb F/C -- 1993-1995
Ski-doo Formula Mach 1 583 Carb L/C -- 1990
Ski-doo Formula Mach 1 617 Carb L/C -- 1991
Ski-doo Formula Mach 1 617 XTC Carb L/C -- 1991
Ski-doo Formula MX 467 Carb L/C -- 1990, 1992
Ski-doo Formula MX X 467 Carb L/C -- 1991
Ski-doo Formula Plus 521 Carb L/C -- 1990-1991
Ski-doo Formula Plus 580 Carb L/C -- 1992
Ski-doo Formula Plus MX 521 Carb L/C -- 1991
Ski-doo Formula Plus X 521 Carb L/C -- 1991
Ski-doo Formula Plus X 583 Carb L/C -- 1992
Ski-doo Formula Plus XTC 521 Carb L/C -- 1991-1992
Ski-doo Formula Plus XTC 580 Carb L/C -- 1990
Ski-doo Formula XTC R 467 Carb L/C -- 1992
Ski-doo Nordik 50 Carb F/C -- 1991
Ski-doo Nordik 60 Carb F/C -- 1991
Ski-doo Safari 377 L Carb F/C -- 1990
Ski-doo Safari 377 LE Carb F/C -- 1990
Ski-doo Safari 447 LC Carb F/C -- 1991-1992
Ski-doo Safari 447 LX Carb F/C -- 1990
Ski-doo Safari 447 LXE Carb F/C -- 1990
Ski-doo Safari 467 GLX Carb F/C -- 1990-1992
Ski-doo Safari 467 LC Carb F/C -- 1990
Ski-doo Tundra 280 Carb F/C -- 1999
Ski-doo Tundra 280 II Carb F/C -- 1992-1998
Ski-doo Tundra 280 R Carb F/C -- 1998-1999

290886725
290886726
420886725
410915200
410916200

Dimensions :
Interior diameter : 40 mm
Exterior diameter : 110 mm
Thickness : 27 mm
Length of wires stator to terminals : 515 mm

Other specifications :
Number of wires : 4
Number of plugs : 0
Number of pins : 4

Wire to wire resistance :
Alternator : Yellow to Yellow/Black = 0.4 ohms +/-20%
Source : Black to Black/Red = 67 ohms +/-20%

Before installing your new stator

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors

Our stator may use a different wire color code than your original.
All of the wires are installed in the correct order; please do not change any of the wiring configurations.
This stator is designed as a direct plug-in replacement and should be used as such.
When bolting stator in, always use locking compound.
If our stator includes a pickup coil, always make sure the air gap is correct upon installation; we suggest as close as possible no less than 0.010??.

Warning:

Risk of electric shock. Disconnect the battery before servicing.
Ensure proper installation by a qualified technician to avoid malfunction.