Tubela Piranha Tube Notcher 

The UK made Tubela Piranha Tube & Pipe Notcher, capacity is from 3/4"OD to 2.5"OD (19mm - 63.5mm) Tube or Box. At any angle or off centre. Just position the tube in the two supplied V-Blocks, tighten the Clamp as needed and notch.

The first notch in a tube or pipe is easily done. However, the Tubela Pirahna Tube & Pipe Notcher makes alignment, off-set and length control of the second, third or forth notches easy to complete accurately.

Use the unique intergrated adjustable 'Stop' to make repetitive notches at the same length; simple and accurate. Pull the Spring Pin to easily remove it, but set, ready for next time.

Its comes in two luxury finishes. Black Zinc or Silver/Colour Zinc plating.

Compound notches are very achievable.

Cuts angles up to 60°.

Utilises a heavy duty Clamp with a magnetic V-Pad to securely hold your tube and allow you to notch on or near to a bend.

Heavy duty 25mm thick high grade S355JR steel frame which is all CNC machined.

Easy mounting: bolt or clamp it to a Welding table (50mm or 100mm centres), Jig table or simply secure it in a vice.

25mm Ground Stainless Steel Shaft that rotates smoothly in a CNC machined bearing block incorporating premium double needle bearings for maximum rigidity and reliability.

Uses inexpensive bi-metal hole saws which you can buy at any good DiY store.

It only requires an ordinary 1/2" hand drill to operate. Ideally a low speed high torque battery drill, running 200-300rpm. Use die-cutting or tapping oil to lubricate the hoesaw.

*drill and holesaw not included*