Product Introduction

Waterproof:The whole sealing construction can prevent moisture from entering the inside of housing.
Dust proof:The full sealed design will prevent the ingress of rain, dust and other foreign matter.

Heat Dissipation:With efficient heat dissipation, the construction of headlight will be protected and its useful life will be extended.

Features

1.High quality lights.Safety and Durable.
2.DOT/SAT approved for street legal. Safety & Fashion.
3.Condition: 100% Brand New and High Quality
4.Material: ABS Plastic Housing / Polycarbonate Lens
5.High grade ABS plastic. For toughness, impact resistance, and heat resistance.
6.Plug and Play Operation, Direct Bolt-On OE Fitment or Replacement for the Stock Unit.
7.Requires no Modification or Drilling.
8.Brings a Different Appearance to Vehicle thats Great for Show Use or to Replace Old and Worn Headlights.

Fits

2002-2005 Dodge Ram 1500

2003-2005 Dodge Ram 2500

2003-2005 Dodge Ram 3500

Product Include

Pair Headlight Assembly Left + Right

Installation
Install:
1.Undo the screws, clips, or retainer springs that hold the headlight in place.
2.Disconnect the wiring from the assembly.
3.Detach the headlight from the vehicle to replace it with a new one.
4.Fit in the new headlight assembly.
5.Fix the new headlight into place and make sure that the screws, clips, or retainer springs used are sealed.
6.Reconnect the wiring that was unplugged from the assembly.
7.Put back the grille and other components that you removed. Seal them back into place.
8.Test the new assembly.

Adjust：
Before you begin to adjust the light, make sure check the alignment of your lights first. Park the vehicle about 10 to 25 feet from the wall with the lights aimed at the wall. The centerlines of the headlights should not be any higher than 3.5 feet above the ground.
1. 【Find the adjustment screws】Firstly, locate the adjustment screws on your vehicle.
2. 【Adjust the headlights individually】The headlights should be adjusted one at a time. Put a rag or towel over a chair in front of the light you want to block. Covering the light assembly directly can damage the plastic lens.
3. 【Adjust the vertical field】The screw on the top of the light housing should be turned clockwise to raise the lights and counterclockwise will lower the light. The headlight should be adjusted until the top of the most intense part of the light beam shines directly on or just below the center of the tape line on the wall.
4. 【Adjust the horizontal field】The screw on the side of the light housing should be turned to get the right/left adjustment correct. Adjust the lens so that the most intense part of the beam is to the right of the vertical line.
5. 【Test your results】

Note

1.Professional Installation is Highly Recommended.
2.Installation Instruction is NOT Included.