911 Motorsports

The 4-Point Jack Adapter gives your jack the versatility to hold just about anything that is large, heavy, and awkward. Install our 1 1/2" Adapter Pin in place of the saddle on your floor jack and convert it to safely hold solid axles, fuel tanks, transfer cases, manual transmissions, bumpers, doors, etc. Modular design allows you to easily configure it for different objects.

We went all the way back to the drawing board for the new 4 point Jack Adapter. It features threaded supports all around and includes a wrench to make adjustments with weight on it. For transmission jacks, the base adapter comes with two bolts to mount it (need to drill your jack plate) and it has two pins that locate the 4 Point Jack Adapter. Base plate is 3/8" thick and threaded for 1/2" bolts which hold the U-slot bars. This design makes it easy to center the jack under the load, then move the supports to find pick points. Threaded supports are 3/4" all-thread that can be replaced with custom lengths, 8" included.

Jack NOT included! Adapter Pins to fit most 1½ to 3 ton floor jacks, check the chart!!!

Confirm your Floor Jack Saddle Mount style:
Fine Thread       - Most common, comes with large washer for jacks with a lip around the threads
Coarse Thread  - Used on Duralast, Torin and potentially other brand jacks
Cross Pin           - Fits most 1½ ton jacks that use a cross pin to retain the saddle
Drop in pin         - Fits older style jacks with 1.17" or 1 3/16" saddle post
Redesigned Transmission Jack base plate mount now available.

- Main bars are 1/4"x 1¼", adjust from 6" to 26.5" wide and provide solid load points.
- Bottom bars are 3/16"x 1", adjust from 5" to 23" wide, they pivot around one bolt and stabilize the load.
- 800 lbs. capacity at maximum extension, using just the top main bars.
- Comes with wrench for adjusting threaded supports and tightening bars.
- Made in Oregon, USA