HOW TO APPLY:
- Before use, remove any loose debris from the work surface and ensure you have adequate safety wear, i.e gloves, suitable protective eye-wear, face mask & clothing.
- NOTE: Following the instructions below, perform a small test application in an inconspicuous area on-site prior to use. This will indicate the suitability and effectiveness of the product for your surface. If unsuitable for your requirements DO NOT PROCEED; contact us to return the product.
- Dependent on the degree of contamination, Grout Haze Cleaner can be used neat or diluted up to 1:10 with water.
- Pre-wet the surface, apply generously and allow the product to dwell for a few minutes before agitating and rinsing off with plenty of clean water.
- Repeat the process if necessary, if using the cleaner indoors ensure good ventilation during and after use.
Important: Grout Haze Remover is not suitable for use with or around acid-sensitive surfaces such as enamel, zinc, chrome, stainless steel, polished marble and limestone, etc.