• Manufactured in the United Kingdom
• 4mm Thickness Structural S275JR Grade Steel
• Zinc Plated and Lacquer Dipped to protect against corrosion
• Designed to fit all Land Rover Discovery 2 Td5 & V8 models
• ALL FIXINGS INCLUDED & some drilling is required
Fitting is done in the following order, and note the brackets are handed so the plate side with 3 holes goes outside the original bracket on the side without a bend.
First remove the lower rear shock eye bolt, insert the bracket and loosely drop the M10x30 bolt through the slot at the bottom. Put the original shocker bolt through the bracket and back into the captive nut, once done the Bottom M10x30 bolt can be tightened.
Once both these bolts are tight you can drill the additional hole on the side of the bracket that has 3 holes. This will receive the second M10x30 bolt which can then also be tightened.
Now that your bracket is fitted you can attach the lower rear shock mounting to the new mounting holes which will be 50mm higher than the original position. New M12 Bolts and nuts are supplied with the kit for this stage.
Please note that all our Ratel-X Industries products are designed for off road use only. The effectiveness of this equipment is directly related to the manner in which it is installed, used, and/or maintained. Proper installation, use and maintenance is solely the responsibility of the installer/user, and will not be assumed by Ratel-X Industries. Ratel-X Industries accepts no liability for loss, damage, injury or death caused by and/or resulting from the use of our parts or products.
A full copy of Ratel-X Industries written warranty and Terms and Conditions is available upon request by contacting us through ebay's message service.