Can Am X3 Radius Rod Support Plates

Supports the weak thin frame area between radius rods.

Is a great addition to a pull plate or if the rear of the frame has seen some damage caused by loose radius rod bolts

Transmission does not need to be pulled out in order to install these plates

Bolts will need to be cut off and new bolts are supplied with this kit along with rivets to hold back plates in place (specify if using aftermarket pull plates or attachments for bolt length)

This kit makes it easier to replace a bent or broken radius rods and will allow only 1 bolt to be removed instead of all the nuts and pull plate from factory

cut off tool and drill are required for install and can be done in less than an hour.