2-10mtr Wiring kit to safely install the Ring RSCDC30 Battery to battery charger.

Supplied with top quality 10mm² 70a leads pre crimped for a simple install saving you time and money on expensive tools

Simply select the kit length required from the drop down menu above for the approx distance between your main starter battery to the leisure battery. 

You will be supplied with everything needed to install this kit

1 x 250mm red 70amp 10mm2 starter battery to fuse holder lead (M8 to M6) terminals
1 x 2-10mtrs red 70amp 10mm2 fuse holder to fuse holder lead (M6 to M6) Terminals
1 x 2-10mtrs Black 70amp 10mm2 Negative battery terminal to negative battery terminal (M8 to M8) Terminals
1 x 250mm red 70amp 10mm2 fuse holder to leisure battery (M8 to M6) terminals
1 x 1000mm black 70amp 10mm2 earth lead for leisure battery (M8 to M10) terminals
1 x pair 8mm post type battery terminals
2 x strip link fuse holders
3 x 40amp midi fuses
1 x pack spare terminals + heat shrink
10 x cable tie bases
15 x cable ties
2 x sticky pads to use on fuse holders if required
15 x 8x3/4 screws
1 x 3mm drill bit
2mtrs black conduit to protect cable
wiring instructions plus after sales support if required

The two long red leads and single black lead shown in the main picture will be supplied as one long lead in your kit with terminals to suit the fuse holders on each end.

This lead will simply need to be cut to suit the location of where the battery charger will be fitted as the connections to the RSCDC30 are via a screw type connections.