Torquewinder Model T5518 - with 1/2" x 18" bars - Fits winding cones with 1/2” nominal pocket diameter

The Torquewinder tool makes the job of winding torsion springs easier and safer than using basic winding bars.  The zinc plated engineered spring - enclosed within a high durability nylon woven sleeve – joins two hardened steel bars for a single, easy to handle, Professional Grade Tool. 


• With a Torquewinder tool, both bars act as a single tool that is easier and safer to handle than 2 separate bars.
• Safer - spring-assist helps bar to fully insert more quickly and stay engaged whenever both bars  are inserted.
• Safer & faster because you won't drop a bar when changing hands!
• Carry Torquewinder in your tool belt / hammer loop going up & down ladders.
• Torquewinder will not roll off a flat surface.
• Torquewinder models available for 7/16”, 1/2”, 5/8” diameter winding cone pockets.

A professional grade tool made for safety and convenience at a Do-It-Yourself price! This tool is made of professional grade hardened steel bars, assembled with zinc plated engineered springs that are protected by a high durability nylon woven sleeve that meets ISO 6945 abrasion standards.


To order the correct tool size, be sure to measure the inside diameter of the torsion spring winding cone pocket.  The winding cone pocket is the round hole (pocket) that the winding bar will be inserted into when winding/unwinding the torsion spring. The torsion spring winding cone pocket diameter is slightly larger than the winding bar diameter to allow for easy fit while winding the torsion spring.



Torquewinder Model T5518 - with 1/2" x 18" bars - Fits winding cones with 1/2” nominal pocket diameter.  18" length for easy handling.

For 1/2" diameter winding cone pockets, use Torquewinder  Model T5518 or T5524.
For 7/16” diameter winding cone pockets, use Torquewinder  Model T5418.
For 5/8” diameter winding cone pockets, use Torquewinder  Model T6624.



For your safety, ALWAYS FOLLOW TORSION SPRING INSTALLATION INSTRUCTIONS & WARNINGS PROVIDED BY TORSION SPRING SUPPLIER.  DO NOT ADJUST, REPAIR OR REPLACE TORSION SPRINGS UNLESS YOU HAVE A THOROUGH UNDERSTANDING OF HOW TO COMPLETE THE TASK AND PHYSICAL CAPABILITY TO WORK WITH TORSION SPRINGS.  ONLY ADJUST TORSION SPRINGS WITH BARS THAT HAVE THE SAME NOMINAL DIAMETER AS THE WINDING CONE POCKETS.  BE SURE TO MEASURE THE DIAMETER OF YOUR WINDING CONE POCKETS** BEFORE PLACING YOUR ORDER.