Creality Ender 5 Plus - CoreXY Conversion - 3D Printer
Converted to CoreXY motion system using:
- BigTreeTech Manta E3EZ Controller Board
- BigTreeTech CB1 Single Board Computer
- BigTreeTech Trinamic TMC2209 EZ Drivers × 5
- Creality CR Touch Probe (High Accuracy)
- MGN12 Linear Guide Rails × 3
- Phaetus DragonFly BMS Hotend
- New Stepper Motors × 2
- BMG Style Clone Extruder
- GT2 Timing Belts
- GT2 6mm Pulleys
Original Creality Components:
- Meanwell 24V Power Supply
- Filament Runout Sensor
- Dual Z-Axis Stepper Drive
- Heated Borosilicate Glass Build Plate
- 20 × 20 Aluminium Extrusions
- 20 × 40 Aluminium Extrusions
Tested, calibrated and fully operational.
This is a sturdy large-format printer with a substantial build volume.
The CoreXY conversion and Klipper firmware allow significantly faster
print speeds and improved motion control compared with the original configuration.
- 0.4mm nozzle, 0.2mm layer height print speeds up to 80mm/s
- Travel speeds up to 240mm/s
- Producing clean PLA and PLA+ prints
- Conversion components are effectively as new and were only used for testing and calibration
Connectivity:
- Ethernet
- Wi-Fi
- USB 2.0
- SD Card
Runs Mainsail with Klipper firmware and can be managed through a standard
web browser from a PC, tablet or smartphone over Ethernet or Wi-Fi.
G-code can be sent directly from Cura to the printer across the network.
The system is configured as a headless setup. The controller provides
DSI, CSI and Micro-HDMI connections should a display and camera be required.
Documentation & Resources