Please note you are only buying the 1 custom hat that goes onto your Popeye Pez. The dispenser is shown just so you can visualize how it looks with your own dispenser. No Pez dispensers included.

This hat was not manufactured by Pez. This is a custom creation.

The hat is close to the original, but not exact. It does hold on, but does not click in super tight. I’ve held it upside down and shook it around and it does not come off, but I’m sure it could come off if you try hard enough since it is lightly secured. If the knob on your Popeye is a little bit worn and doesn’t hold on tight just use some of that tacky tape for holding posters up and that will hold it fine.

This is 3d printed.

A great way to finish off your Popeye Pez that has been missing his hat!

Shipping is a flat rate of $6.00 for one or more.