| Attribute | Information |
| Part Name | AC/Heater Climate Control Module / Dashboard Temperature Switch |
| OEM Part Numbers | 27510-ZB000, 27510-ZB005, 27510-ZB00A (27510ZB000) |
| Placement on Vehicle | Center Dashboard Lower Console Stack (Below Audio Unit) |
| Color / Finish | Factory Matte Charcoal Black / Dark Slate ABS |
| Control Layout | Triple Rotary Dial Layout (Manual A/C, Recirculation, Rear Defroster) |
| Chassis Platform | L31 Third-Gen Nissan Altima Sedan (2.5L QR25DE / 3.5L VQ35DE) |
| Fitment Type | Direct Replacement Mechanical Bolt-In & Harness Plug |
| Fitment Years | 2005, 2006 (Third-Gen Facelift Altima Models) |
| Condition | Used OEM (Original Equipment Manufacturer) |
Up for sale is a genuine OEM Nissan center dashboard manual climate control switch and temperature regulator module removed from a running 2006 Nissan Altima 2.5 S Sedan. Finished in factory-original Charcoal Black and featuring the standard 27510-ZB layout, this unit is engineered as a direct plug-and-play drop-in replacement.
Ideal Solution For Fixing:
Sticking, slipping, or loose temperature/fan speed rotary knobs
Non-responsive A/C compressor, recirculation, or rear defrost push-buttons
Faulty air vent distribution routing
Dead nighttime backlighting
Cracked or broken mounting tabs behind the center console
As an authentic factory-original component, this module features exact perimeter mounting screw tabs and rear electrical harness docks. Genuine Nissan OEM units are strongly recommended for the L31 platform over generic aftermarket options, which frequently suffer from sub-dash alignment issues, cheap internal contact pins, electrical resistance glitches, and premature wear.
Every function on this unit—including dial click detents, push-button microswitches, and internal circuit pathways—has been fully bench-tested and confirmed operating perfectly.
⚠️ IMPORTANT FITMENT WARNING: Please verify your original module's part number and layout prior to purchase.
Compatible Models: Fits 2005–2006 Nissan Altima Sedan (Base, 2.5, 2.5 S, and 3.5 SE trims) equipped with manual triple-dial climate controls.
Will NOT Fit: Automatic digital climate control panels featuring integrated LCD temperature screens (commonly found on 3.5 SL or SE-R trims).
Will NOT Fit: Early 2002–2004 pre-facelift Altima models (uses different dashboard center stack bezels and connector pin layouts).
Smooth Rotary Dial Action: All three primary dials (fan speed, temperature mix, and vent distribution) turn with firm, precise click-detent indexing points with zero binding or gear slipping.
Tested Switch Controls: Integrated push-buttons for A/C compressor, air recirculation, and rear defroster register instantly without sticking or dropping connection.
Clean Cosmetic Condition: Faceplate text, symbols, and indicator lines are clear and intact with only minor standard signs of use—free of rubbed-off text, sticky surface decay, or deep gouges.
Straight Connecting Terminals: Rear pin docks are 100% straight, unbent, and clean to ensure a static-free connection with your factory harness.
Remove Console Trim: Gently release the surrounding center stack/shifter trim bezel using a soft plastic trim wedge tool.
Unbolt Old Unit: Back out the structural retaining screws securing the climate unit to the sub-dash cage framework.
Swap Electrical Harnesses: Pull the module forward, disconnect the rear factory multi-pin terminal blocks, and transfer them directly to your replacement module.
Reassemble: Seat the new unit flat into the center stack framework, tighten down the mounting screws, and press the cosmetic trim panels back into place.