- BIOS:
- Automatic CPU and board configuration
- Supports Plug and Play configuration of peripheral devices and expansion cards
- Manageability:
- ATX power supply connector
- ACPI and previous PMU support, suspend switch, keyboard power on/off
- Supports Wake on Modem, Wake on LAN and Wake on Alarm
- On-Board Audio:
- Complies with the PC98 audio specification
- 16-bit CODEC for full-duplex playback and recording
- HRTF 3D professional audio supports both Direct Sound 3D and A3D -compatible interfaces
- Supports Front Left/Right, Rear Left/Right Surround and Center/Subwoofer (Low-Frequency Effects) 6 channel audio-out
- Driver support for MS-DOS, Microsoft Windows 95/98/2000/NT 4.0
- Built-in 32ohm earphone buffer and 3D surround sound
- Provides MPU-401 Game/MIDI port and legacy Sound Blaster 16 support
- Downloadable Wave-table Synthesizer supports Direct Music
- Stereo Mixer supports analog mixing from CD-Audio and Line In
- On-Board Video:
- Onboard 128-bit 2D/3D 100MHz Host interface AGP Graphics Accelerator Complies with AGP V2.0
- Shared memory architecture allows a maximum of 64 MB main memory to act as frame buffer
- Supports high resolutions up to 1920x1200 16M colors, up to 2048x2048
- Texture size and Virtual screen up to 4096x4096 Supports hardware DVD Accelerator
| Motherboard Specifications - Model:
- Pc chips M758 Motherboard
- Processor Support:
- FCPGA Celeron: 300~966 MHz, FSB: 66 MHz FCPGA
- Pentium III: 500~1130MHz, FSB: 100MHz, 133MHz
- Tualatin/Tualatin Celeron: up to 1.2GHz, FSB: 100MHz(only for model M758LRT+ and M758T+)
- Chipset:
- FSB:
- Memory:
- Two DIMM slots for 168-pin SDRAM memory modules
- Support for 66MHz, 100MHz, & 133MHz memory bus
- Maximum installed memory is 2 x 512MB = 1 GB
- Expansion Slots:
- On-Board LAN:
- 10BaseT/100BaseTX Ethernet LAN
- LAN controller integrates Fast Ethernet MAC and PHY compliant with IEEE802.3u 100BASE-TX, 10BASE-T and ANSI X3.263 TP-PMD standards
- Compliant with ACPI 1.0 and the Network Device Class Power Management 1.0
- High Performance provided by 100Mbps clock generator and data recovery circuit for 100Mbps receiver
- Rear Panel I/O Ports:
- Provides PC99 Color Connectors for easy peripheral device connections
- Floppy disk drive connector with 1Mb/s transfer rate
- One serial port with 16550-compatible fast UART
- One parallel port with ECP and EPP support =Two USB ports and two PS/2 ports for keyboard and mouse
- One infrared port connector for optional module
- Internal I/O Interface:
- Primary and Secondary PCI IDE channels
- Support for PIO (programmable input/output) modes
- Support for Multiword DMA modes Support for Bus Mastering and Ultra DMA 33/66/100 modes (the Ultra DMA 100 mode is optional)
- Form Factor:
- Micro-ATX form factor (24.4cm x 19cm){ 9.61'' x 7.48''}
|