10 x NVM NT1016 / Ellard - Remote Control Duplicator for Roller Shutters 433Mhz
Features:
- Single Channel
- Fitted with Replaceable Long Life Lithium Battery
- Up / Stop / Down Buttons
- Front Sliding cover to prevent accidental operation of the shutter
- Chrome Finish
- Keyfob clip
Product Codes:
- NT1016 is Compatible with all NVM Controllers NT1004, NT1006, NT1103 v2, NT1008, NT1019, NT1105
- Compatible with NT1103 v2+ supplied after May 2012.
- Please check installation date before ordering this product if using NT1103.
Technical Specifications:
- Channels: Single Channel
- Frequency: 433mHz
- Random Codes: 5 million
HOW TO PROGRAMME NVM / ELLARD REMOTE CONTROL
PROGRAMMING
1. The Remote controllers (main box) are equipped with a studying key and studying pilot lamp LED1. This is a small black button in the main box
2. Press and hold the studying key for about 1-2 seconds in the main box and the LED light should flash on.
3. Press the button with the circle sign on the remotes for programming.
4. Check that your remote is fully programmed by trying the other keys.
5. If you have other remotes, please repeat steps 1-4 above.
DELETION
Press the setting button (SW6) of the receiver for about 4 seconds until the FD2 light begins flashing and then quickly release the button.
Press the setting button (SW6) of the receiver again within 6 seconds until the FD2 light stops flashing. The memory of the receiver is now cleared.
1. The Remote controllers (main box) are equipped with a studying key and studying pilot lamp LED1. This is a small black button in the main box
2. Press and hold the studying key for about 1-2 seconds in the main box and the LED light should flash on.
3. Press the button with the circle sign on the remotes for programming.
4. Check that your remote is fully programmed by trying the other keys.
5. If you have other remotes, please repeat steps 1-4 above.
DELETION
Press the setting button (SW6) of the receiver for about 4 seconds until the FD2 light begins flashing and then quickly release the button.
Press the setting button (SW6) of the receiver again within 6 seconds until the FD2 light stops flashing. The memory of the receiver is now cleared.
If you have any problems or need help with the order, please get in touch.
We are here to help you.
Please do not just leave bad feedback without giving us a chance to help you.
Please do not just leave bad feedback without giving us a chance to help you.
We have repaired over 10'000 garage doors and with over 20 years experience we know 'garage doors'
We are only a phone-call away.
