Surface Roughness Standard Test Block Square Wave RA 3.2μm Multi-Engraved Lines


◆Widely applicable for the calibration of readings on various domestic and imported roughness measuring instruments, including pocket-sized roughness testers, portable roughness testers, handheld roughness testers, and bench-top roughness testers.
◆Glass-based surface roughness multi-scratch pattern gauge | Calibration block conforming to ISO 5436-1:2000.

Calibration Standards of the Metrology Institute
◆----High hardness glass substrate with no deformation
◆----High surface precision
◆----Resistant to scratches
◆----Long service life
◆----Fully Compliant with GB/T19067.1—2003 and ISO5436—1:2000 Standards
◆----Minimal Influence from Stylus Radius Variations
◆----Utilizes simulated sine profile grooves and triangular profile grooves, minimizing stylus radius variations and ensuring high calibration accurac

Introduction:
◆Square Wave (Standard waveform with rectangular profile. Currently, nearly all domestically produced roughness testers are equipped with square wave standard blocks due to their low cost).
◆RA=3.2μm
◆Please note that Only A Calibration Block in the package.