This holds the Ryobi 18v One+ Bug Zapper vertically and can be mounted to the Wall, Ryobi Link Wall Rails, or Pegboard*. It is designed specifically to hold the Ryobi Bug Zapper model #P29140VNM. The Ryobi 18v One+ battery must be removed and the bug zapper mounts onto a portion of the holder that is similar to the battery. It includes 6 pegs: 3 curved and 3 straight if you choose to mount it to pegboard.

The Ryobi Bug Zapper shown in photos is NOT included and for reference purposes only. While it may hold other Ryobi 18v One+ Tools, it is ONLY designed to hold the Bug Zapper. It is NOT designed to hold any other tools (nor from any other brands).

If mounting to the wall with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw (not included) to hold it into place.

* Note that there are many different types of pegboard and some may not work. This is designed to work on 1/8" thick masonite pegboard with holes at 1" (25.4mm) on center only.

Holder Dimensions: 2.5" x 4.6" x 6.8" (62mm x 117mm x 173mm)

These are uniquely designed and 3D-printed by the Seller in the USA. There is no warranty and are sold as-is. Items are lightweight and made of PETG plastic thus we cannot warrant that deformations or failure may occur due to extreme temperatures, stress, or weight. Due to the printing process, there may be some minor imperfections which are mostly likely to be on the bottom/back side, not exposed to view. 3D Printing involves the heating and depositing of material on a flat board one layer at a time, thus most exposed sides have small, fine lines. Infill (non-exposed) areas are not solid plastic.