You will receive a kit of parts that includes the following:-

Rear wing main section - printed in PLA material
Rear wing DRS flap - Printed in PLA material
DRS mechanism cover - Printed in PLA material

DRS mechanism, 3 parts in total, all printed in Glass reinforced ABS

A length of 1mm Brass rod for you to cut into lengths to make the hinges.

Available with Black or Red main section, flap & mechanism cover, unless requested otherwise I will send Black

Measures W149mm H75mm D80mm

All parts unpainted so you can paint or sticker to match your favorite team, or just leave unpainted.

Simple assembly as follows:-

  1. Cut the Brass rod to the correct length
  2. Push the now cut Brass rod into pivot holes, use a tiny bad of super glue on one the end to retain
  3. Slide the DRS mechanism & mechanism cover into place (it's quite snug so no glue required on this)
  4. Add final pin into the top of the mechanism/DRS flap.
As this is a kit, it will require some fettling to suit during assembly.