This phonograph is missing parts and has not been tested, so it is being sold as is for parts, repair, restoration or display only. The unit is missing the reproducer, reproducer arm assembly, rear horn support bracket and the horn. The small bolt holding the mandrel into place on the top right of the bedplate is also missing. Exterior case measures approximately 12 inches long by 9 1/2 inches wide by 11 1/2 inches tall including the top handle. The exterior of the case is quite dirty and dusty throughout and shows moderate to heavy scratching, scuffing, general wear and finish wear throughout, which is especially heavy on the exterior of the lid throughout. There are some areas of moderate but relatively shallow veneer flaking along the top left and right side edges of the lid. Both of the side lid securing brackets are intact. There are some areas of finish touch up in various places throughout the exterior, mainly on the front center, along the top edge and along the right side throughout. All of the rubber feet are missing on the bottom of the case. The bedplate is moderately dirty and dusty throughout and could use a good cleaning. The bedplate shows moderate scratching, scuffing, general wear and paint wear throughout from age and use, especially along the exterior edges and corners throughout. The majority of the original pin striping is missing, especially on the front half throughout. The mandrel shows moderate to heavy scratching, scuffing, tarnishing, general wear and plating wear throughout. The motor is quite dirty and dusty throughout and has areas of caked on oil and grease throughout. The motor has some areas of light to moderate surface rusting in various places throughout. The motor runs loud and quite fast and the governor weights seem to be stretched out moderately, so some adjustment and repair will likely be needed. The interior spring appears to hold tension as it should, but makes an unusual, non-typical clicking sound when it is wound. The spring may have some damage to it, but it is not possible to tell without disassembly. In any case, the spring will probably need to be cleaned and regreased due to age. The lower interior of the case is very dirty and dusty throughout and could use a good cleaning. The crank shows moderate to heavy surface rusting throughout as well as heavy finish wear throughout the surface of the handle. See pictures for a better idea of condition.