NAME: Part 15 security/remote control transmitter
1. How to use first：
1) Apply 12 to 24 VDC to the receiver board at the terminals provided.
2) Install a 12V A23 battery in the transmitter (available in any hardware store).
3) Press any butTransmitter
Operating Voltage: 12V
Operating Frequency: 433Mhz
Battery Type: 12V 23A(not included)
Remote Distance: 150m
DIM: 130 x 50 x 18mm(L x W x T)
Receiver
Input Voltage: DC 12V
Max load: 7A
DIM: 120 x 50 x 15mm(L x W x T)
Brand Name:
Weight:264g

Operation Way and Steps:
1. Factory Default is Inching Mode.
Press and hold the button A, the Receiver A (Relay A)turns on; Release the button A, the Receiver A (Relay A) turns off.
2.Self- lock Mode:
Press the button A, the Receiver A (Relay A) turns on; Press the button A again, the Receiver A (Relay A) turns off.
3.Inter- lock Mode:
Press the button A, the Receiver A (Relay A) turns on; Press the button B, the Receiver B (Relay B) turns on, the Receiver A (Relay A) turns off.

Change the factory default mode to other two working mode
1. Clear:
Press and hold the learning button on the receiver board, for several seconds, till there is a sound, then release the learning button. It means clearing succeed, previous mode will not work after clearing successfully.
2. Choose the Working Mode:
There are four solder pins and 2 jumper caps on the receiver board.
1)Use the Jumper cap to cover position "3" & "4", leave the position "1" & "2" empty, all the 16 relays¡¯ working mode is Inching Mode
2) Use the Jumper cap to cover position "2" & "4", leave the position 1 & 3 empty, all the 16 relays¡¯ working mode is Self-lock Mode.
3) Use the Jumper cap to cover position "1" & "3", leave the position 2 & 4 empty, all the 16 relays¡¯ working mode is Inter-lock Mode.


Package Includes:
2 x Transmitters (Battery is not included)
1 x Receiv
NAME: Part 15 security/remote control transmitter ，Sixteen Channels of output,the output can be independent.remote distance: 150m (Theoretical value)
Using wireless encoding technique,no direction,no mutual interference
Can switch the working mode between inching(Factory Default), self-locking and interlocked.Mainly applied for: Remote control of the on and off of pump,machine-tool,LED lights and other civil and industrial supporting remote areas
how to use :1) apply 12 to 24 Volts DC to the receiver board at the terminal provided. 2) install a 12V A23 battery in the transmitter (readily available at any hardware store) 3) verify transmitter works by pressing any button and observing red LED light up at top front of transmitter 4) hold learning button down on receiver board until 2 beeps are heard, then release button
5) press learning button briefly. An LED near the button will be lit. 6) On the transmitter, press the button corresponding to the desired mode (buttons 1, 2, or 3). Mode is now set.