Mounting for Starlink Mini dish on a Fiat Ducato, Citroen Relay, Peugeot Boxer roof.

Available with standard hex drive fasteners, or for added peace of mind & even higher security, Torx head fasteners, supplied with correct sized Torx drive bit for your convenience.

This mounting is designed to be bonded to the roof of your camper van, there are holes to allow for water drainage also. The dish is then fitted into the mount & retained using the supplied corner clamps & stainless fasteners that fasten into metallic inserts in the plastic for strength.

The cable entry hole is nicely radiused to avoid damage to the cable & there is even a thoughtfully provided cable storage port that keeps water out of the power & ethernet jacks should you remove the dish, rather than leave the end of the jacks open to rain water damage.

Should you wish to remove the dish from the mount, four finger recesses on the sides make this super easy, so you can actually get hold of the dish, unlike those that are fully flush where you have to lever the dish out, potentially damaging it.

The seating area for the dish is angled to precisely match the angle on the housing, so avoiding damage to the dish housing from sharp corners.

Due to an improvement in our production facility, these are now supplied in TWO sections rather than the FOUR shown. They still push together beautifully, no glue required as once bonded to the roof the sections will not come apart.

Manufactured to order in White, Black or Grey tough UV resistant polymer.

Assembled dimensions 345mm x 305mm x 55mm