Mounting for Starlink Mini dish on a motorhome roof.

This mounting is designed to be bonded to the roof of your camper van & has holes to allow for drainage incorporated, don't be fooled by "professionals" telling you that it needs to be bolted down, using Sika 522, the bond area on this mount gives you pull off strength of over 4000kg!!!!!!.

Available with standard hex drive fasteners, or for added peace of mind & even higher security, Torx head fasteners. The threads for these fasteners are by way of proper, heat set inserts, as opposed to standard nuts as offered by some "professionals"

The cable entry hole is nicely radiused to avoid damage to the cable & there is even a thoughtfully provided cable storage port that keeps water out of the power jack should you remove the dish, rather than leave the end of the jack open to rain water damage.

Should you wish to remove the dish from the mount, four finger recesses on the sides make this super easy, so you can actually get hold of the dish, unlike those that are fully flush where you have to lever the dish out, potentially damaging it.

The seating area for the dish is angled to precisely match the angle on the housing, so avoiding damage to the dish housing from sharp corners.

Finally, there is a drain point in each corner, so rain water will drain away no mater what angle your vehicle is parked at.

Supplied in two sections that push together beautifully, no glue required as once bonded to the roof the sections will not come apart.

For those with a Ducato based van conversion I have a proper, profiled mounted to match the roof ribs listed on Ebay.

Due to an upgrade in our production facility, these are now supplied in TWO sections rather than the FOUR shown. They still push together beautifully, no glue required as once bonded to the roof the sections will not come apart.

Unlike some "professional" sellers, we do not try to attract sales by offering cheap, inferior material such as PETG, then jack the price up if you want a quality material, all of our mounts have been, and will always be made from premium, UV & heat resistant materials, we will not compromise quality just to get a sale & we do not claim to be the cheapest, but aim to be the best.

Manufactured to order in White, Black or Grey tough UV resistant polymer.

This design is protected by the Intellectual Property Office,  registered design number 652442

Available with standard hex drive fasteners, or for added peace of mind higher security Torx head fasteners.

Assembled dimensions 345mm x 305mm x 55mm