Dechrome kit also known as Blackout and Chrome Delete
You will receive a 100mm x 10m roll of Matte Black Vinyl 
10m is plenty to dechrome a medium sized vehicle 

Top Quality wrap film, you will require a specific wrap film in order to successfully dechrome a vehicle. There are lots of kits available on line that are standard

Can be used on Door Pillars to freshen up hide scratches or dechrome.  

Why Choose Our Vinyl?

Weather and UV Resistant: Built to withstand harsh conditions, ensuring your vehicle maintains its New Product look for years to come.

Chrome Protection: Shields chrome parts from damage caused by chemicals and environmental factors, extending the life of your car's exterior.

Removable and Reversible: The vinyl can be easily peeled off without leaving residue, allowing you to return to the original chrome finish if desired.

 
Always ensure the vehicle is clean of contaminants prior to application. 

We would not recommend applying any vehicle graphics/wrap to paintwork that is damaged or substandard 

Fitting 

      The application temperature is crucial to the success of this product. The air temperature and temperature of the material must be between 18-23 degrees. Any lower or higher will cause application issues. As winter draws in you will need to fit indoors in a controlled environment / Heat gun

       Clean the area you want to wrap thoroughly and avoid using greasy cleaners, alcohol wipes are a great tool if you don’t have the correct pre wrap cleaners. Ensure the surface is bone dry before attempting to apply the film.



 Stick to the area to be wrapped. Reposition if necessary. The adhesive has microscopic air channels so you can work trapped air out with your squeegee or wrapping glove. Leave for a short time to allow adhesive to start to cure. You may need to tuck in or trim excess material. Remember if you are tucking the material to ensure the hidden area is also thoroughly cleaned.

    Leave overnight for adhesive to cure.

As this is a cast material it is conformable with a little heat. If you are following curves warm the material very slightly and work the material to shape 

Make sure you don’t try to work the material with the heat source still on it or if it is too hot, as this will stretch and ruin the material.