Fitting Instructions:

- Thoroughly clean the inside of the windscreen using methylated spirit.
- Although the strip can be applied dry, it is recommended to wet the surface of the screen with water containing a small amount of washing up liquid. Spray or sponge this solution to the top of the windscreen.
- If you are mounting the strip on a front windscreen which has a screen mounted rear view mirror, you will need to cut an appropriate sized hole in the strip.
- Remove the backing paper from the Sun Strip.
- Place the strip on the top of the screen and ensure that the side against the glass is the one which was against the backing paper. THIS IS VERY IMPORTANT.
- Draw a rubber squeegee or clean cloth across the strip from the centre to each end, forcing out air bubbles and any excess water.
- Trim and cut off all except 2.5cm (1”) of the surplus length at each end with a sharp instrument, but trim to a perfect fit about 24 hours after fitting (there may be slight shrinkage).