Welcome to intelli-ink!

This is a Bronze Bush/Bearing & Blanking Cap Upgrade + FITTING INSTRUCTIONS

For the More Recent 1600 Watt Version Of The Bosch GKS 65 Saw.

I have included a photo of the GKS 65 in this listing so please compare it with your saw.


This Upgrade Will Eliminate Excessive Blade Wobble Often Found On These Saws.


Test your GKS 65 saw now by rocking the blade side-to-side. If it wobbles then your saw has this bearing problem and will need to be repaired. 


The Bosch GKS 65 Circular Saws often suffer from excess play in the shaft even from new. This causes the blade to wobble as much as 3mm!!


This results in inaccurate cuts, a poor finish, excessive saw noise and vibration. It can also cause damage to your saw over time.

Note: This bearing comes with fitting instructions with photos and the whole procedure takes about 45 mins to do.
                         

Once this bearing has been fitted you will notice a big increase in cut finish and accuracy.


Advantages of using a Bronze Bush/Bearing are:

1. Greater Surface Area compared to a needle bearing.

2. Bronze Is Self Lubricating.

3. Reduces Saw Noise & Vibration.

4. Will last for many years.

5. Once your upgrade is complete the shaft will run on a thin film of grease on the inner surface of the bearing which provides a superior ultra-smooth bearing surface.

This Bronze Bush replaces the original needle bearing which often have a lot of play in them and cause the blade to wobble even when the saw is new.