The Multiply is a add-on for the ZX Dandanator that allows games to be loaded from micro SD Card.

Now includes a 3D printed case. As with all 3D prints there may be some small imperfections. 

(I've left the older photos in the listing showing the PCB without the 3D Case)

This PCB is based on the original design by Mad3001

Included is:

1 x Multiply board (Assembled and programmed)

1 x DB9 cable for connecting the Multiply to your Dandanator

(SD Card and Dandanator as shown in the photo is not included)

You need to already own a ZX Dandanator in order to use the Multiply as its an addon board.  You will also be required to make a small modification to your Danadanator board and solder in a wire as well as install multiply specific firmware on your dandanator.  Instructions are in the document below:

eBay does not allow posting of links so for detailed instructions Google:

github mad3001 Multiply

Under the Docs folder there is a excellent instruction manual by mad3001 on how to modify and setup your Dandanator for the Multiply. The Multiply has already been programmed.