 |
| AUTOOL CT60 automotive fuel injector testing and driving tool can accurately detect faults such as injector sticking, leakage, and poor atomisation. It can also be used with cleaning equipment to perform pulse-driven cleaning. The device supports 12V conventional injectors as well as 75V turbocharged fuel injection and GDI injectors. It allows setting multiple pulse outputs and adjusting parameters such as speed, pulse width, and working time as needed. Additionally, it can connect two injectors for synchronous testing to compare injection performance and spray angles. Compatible with various injector testing and cleaning equipment, it comes with a 3-year warranty and lifetime technical support. |
 |
 |  |  |
Solve Common Failures Of Fuel Injector Easily solve common faults such as stuck,blocked,leaked,or insufficient combustion of the fuel injector. | Dual voltage compatible Supports 12V conventional fuel injectors and 75V high-voltage GDI/turbocharged injectors without additional equipment | Wide Operating Frequency & Time Range The operationg frequency range can reach 600-4000rpm,the operationg time setting range can reach 0-99mins |
 |  |  |
Perfect Match Can be used with an ultrasonic cleaning machine as a GDI engine injector drive upgrade module, without the need to replace the entire set of equipment, reducing upgrade costs. | Suitable for most car models comes with 2 adapters with interface diameters of 10mm and 15mm respectively | Package List 1pc* CT60 Automotive Injector Tester main unit 2pc* Injector connector 1pc* Pulse Power Cord 2pc* Injector Adaptor Cable 1pc* Battery clips 1pc* Power supply cable 1pc* User manual |
 |
Operation Instruction： 1.Turn off the vehicle's engine and remove the fuel injectors from the engine. 2.Connect the pulse output to the power input port on the fuel injector. 3、Connect the positive and negative electrodes clamps to the 110V/220V power. 4.Press RPM "+" "-" key to select the required analog speed. Press "Start" button, then the device starts working. 5.Select the required injector. 6.Put the device into the connection equipment, and then press the carburetor cleaner. 7.Press RPM "+" and "-" keys, the tester will output pulse to the injector, and then the pulse signal indicator will light up. The device will start working. 8.Use self-pressure detergent, you need to select the corresponding connector and connect it well. Press the start button to start spraying, and observe the sprayability status and spray angle with your naked eye. |
 |  |  |  |  |  |
 |  |  |  |
 |  |  |  |
 |  |  |  |
 |  |  |  |
