Each surface drug test kit will screen for the presence of each of the following 10 drugs with individual results positive or negative for each drug group:

  • Opiates (heroin) MOP
  • Ecstasy MDMA
  • Cocaine and Crack COC
  • Amphetamine, speed, whiz AMP
  • Methamphetamine, Crystal Ice MET
  • Methadone MTD
  • Benzodiazepines, tranquilizer, date rape BZO
  • Ketamine KET
  • Buprenorphine BUP
  • Cannabis, marijuana, skunk THC

How to perform the surface drug test

  1. Read the instructions supplied with the test kit before you begin the test
  2. Remove the surface drug test kit from the foil pouch
  3. Remove the cap
  4. If you are wiping a surface then wipe the prongs along the surface making sure that the prongs on both sides of the panel come into contact with the surface you wish to test. 
  5. The buffer solution previously supplied with this test has been replaced by simply adding 5ml of cold tap water to the test prongs
  6. Take the cap that was removed from the drug test, hold it upright, and pour the water into the cap. Alternatively, immerse the prongs up to the dip line indicators for 15-20 seconds, using clean tap water in a suitable container.
  7. You can then lie the test kit flat with the cap still on 
  8. Read the result at 5-10 minutes
  9. You will get an individual result for each drug

How to use the surface drug test kit to test a suspect substance or white powder

Follow steps 1, 2 and 3 as above

  1. If you are using the test kit to test a white powder then you can either wipe all the prongs through the suspect substance or you can add the white powder directly to 5ml of clean cold tap water (if doing this mix thoroughly)

Then follow all the other steps as above

If you wish to test a tablet, then crush it and add the powder to the 5ml cold tap water and mix, and then follow the steps as above.