Due to changes in shipping rates, the prices shown are approximate; please send a message with your address for an exact price.

The Commodore cross cable gives a parallel connection between two Commodore machines using the user port.


Hardware requirements

You need the following hardware to make use of this cable:

Software support

The cable is supported by the following Commodore software:

Usage

Switch both Commodore machines off. Connect the user port plugs onto the user ports of both Commodore machines, being very careful not to do it upside down. Switch both Commodore machines back on.

Important! Do not plug or unplug cables while your equipment is switched on. Make sure that all components of your equipment are connected to the same, properly grounded power outlet. Put your equipment far away from monitors, TV sets and other devices with strong emission, otherwise cables may pick up interference and you may experience data loss or corruption.



( Description taken from: https://sta.c64.org/cbmcross.html)

The connectors have a key pin, so you can't plug it upside down.

We are not responsible for any damage caused by the use of this cable; use it at your own risk.