The card slot is moulded into the back of the case in the same clear material, so it carries a card without breaking up the look of the phone underneath. One card goes in from the top — a travel card, a door fob, a bank card for the shop — and the case stays thin enough to slide into a pocket. The four corners are built up thicker than the sides, which is where a case takes most of the impact when a phone goes off a table edge. Raised lips sit proud of the screen and around each camera lens, so the glass stays off the surface when the phone is face down or lying on its back. The shell is clear throughout, including the slot, so the phone’s own colour shows through.
| Built-in clear card slot Carry one card without a separate wallet. |
Reinforced corners Thicker at the four corners where impact lands. |
| Raised camera rings Each lens sits below the edge of the case. |
Raised screen lip Keeps the glass off the table when face down. |
| Fully transparent Shows the phone’s own colour and finish. |
Slim profile Slides into a pocket with the card in place. |
| Type | Clear Case with Card Slot |
| Material | Silicone |
| Camera Protection | Raised lens rings |
| Compatible Models | For iPhone 12 - 18 (Pro, Pro Max) |
| 1 | Check your exact iPhone model before ordering and select it from the options. |
| 2 | Ease the phone in bottom edge first, then stretch the top corners over. |
| 3 | Run a finger round the edge to check the case is seated flat all the way round. |
| 4 | Check the camera, charging port, speaker and buttons all line up before use. |
| 5 | Slide one card into the slot from the top opening. |
| 6 | To remove the card, push it up with your thumb through the opening. |
| 7 | Remove the card before putting the phone on a wireless charger. |
| 8 | Clean with a slightly damp cloth and let the case dry fully before refitting. |