Focusable Dot Laser Module With Driver

Package: 1pc Laser, 1pc 3pin cable, 1pc 3pin-4pin cable

Laser Features:

Laser Interface: 3PIN (PWM GND 12V+),
Laser shape:Dot
Focusable:YES
Modulation frequency: TTL/PWM, TTL controls switch, PWM controls output.

Fan Cooling
Working Voltage: 12V
Case Material: Aluminum
Warm-up time: None
Operating Temperature: -40 ℃ ~ +50 ℃
Storage temperature: -40 ℃ ~ +50 ℃

The laser interface has three pins, with the red wire connected to a 12V+power supply, the yellow wire connected to a PWM+signal, the black wire connected to a power supply GND, and the white wire connected to a signal GND. The power supply and signal are grounded together! If the signal is not connected, simply connect 12V+and GND to emit light! No need to connect the signal again, the signal is only used to control the switch or adjust the power!

Recommended engraving distance: 2-10cm

405nm 500mW Combustible materials: wood, paper, plastic, leather, bamboo, rubber, gourds and other materials that can be burned by fire. Can be cut: thin paper can be cut, other materials basically cannot be cut!

2.5W--5W Combustible materials: wood, paper, plastic, leather, bamboo, bone, ivory, horns, rubber, acrylic, shells, gourds and other materials that can be burned by fire. Metal category: ordinary metal spray paint and paint.

Can be cut: ≥2.5W can cut 1mm linden wood, 1mm (kraft paper, leather, non-woven fabric, non-woven fabric), etc.