The Custom 3D printed GI Joe Adventure Team Big Trapper replacement connector is designed to replace the sometimes missing or broken black plastic connector that connects the front cab to the rear section.  It comes in 2 sizes, short and long.  Unlike the original connector, the replacement connector is made of rigid PLA plastic and open on both ends allowing your Joe's to crawl through it from the back of the vehicle to the front cab.  There is also an optional custom seat replacement printed in black plastic PLA filament that will replace the original cardboard seat.  This custom seat, with cut-out in the center, will allow your Joe's to crawl through the hollow connector tube from the back of the trapper to the front cab.  There is also a full version of the seat available, without the cut-out, if preferred.