VELVET Split Cambered Ergonomic Mechanical Keyboard
2.4G Wireless Hot-Swap VIAL Programmable Dual 1200 mAh Low Profile Layout
⚠️ Read before ordering:
• 2.4G only — not Bluetooth. A USB-A 2.4G receiver is required for typing.
• USB-C port is for charging (not a wired typing mode).
• Each half has its own power switch and USB-C charging port — turn both ON to use.
• Arc-shaped case is PLA 3D-printed: fine surface textures/variations are normal.
• Kit options ship without switches/keycaps; choose a switch package if you want ready-to-type.
• 2.4G only — not Bluetooth. A USB-A 2.4G receiver is required for typing.
• USB-C port is for charging (not a wired typing mode).
• Each half has its own power switch and USB-C charging port — turn both ON to use.
• Arc-shaped case is PLA 3D-printed: fine surface textures/variations are normal.
• Kit options ship without switches/keycaps; choose a switch package if you want ready-to-type.
✨ Features
🧩 Ergonomic Split & Camber — column-staggered layout reduces wrist deviation
📶 2.4G Wireless — low-latency link via included receiver
🔄 Hot-Swap Sockets — change switches in seconds (no solder)
🧠 VIAL Programmable — layers, macros, per-key mapping
🔋 Long Battery — 1200 mAh × 2 polymer cells included
🛠️ Serviceable Design — separate battery switch & easy USB-C charging
📊 Specifications
Connection: 2.4G wireless (USB-A receiver required)
Charging: USB-C (per half)
Batteries: 1200 mAh Li-polymer × 2 (included)
Case: PLA 3D-printed, cambered/arc geometry
Programmability: VIAL (on-board)
Hot-Swap: Yes (switch-type per variant)
📦 Package Options
| Variant (as shown on page) | What’s included |
|---|---|
| Hot-swap / VIAL (Kit) | Keyboard halves with electronics & batteries; no switches/keycaps. |
| HiFi Switch Version | Assembled set with “HiFi” tactile/linear switches + keycaps. |
| Silent Switch Version | Assembled set with silent switches + keycaps. |
| 2.4G Wireless Hot-swap / VIAL | Wireless kit/assembled (per selection) + 2.4G receiver. |
Note: Type-C cable not included; please use your own 5V charger/cable.
🧭 Quick Start
1) Charge both halves via USB-C → 2) Turn both battery switches ON → 3) Plug the 2.4G receiver into your PC/Mac → 4) If using a Kit, install switches & keycaps → 5) Open VIAL to customize layers and mappings.
❓ FAQ
Q: Can I use it over Bluetooth?
A: No. This model is 2.4G wireless only (receiver required).
Q: Does USB-C allow wired typing?
A: USB-C is for charging. Typing is via the 2.4G receiver.
Q: Why do I see fine lines on the case?
A: The cambered shell is PLA 3D-printed; light texture/variations are expected and cosmetic.
🖼 Product Images
