Scratch protection film for horn levers. It can also be used as an anti-slip substitute. The film's high curvature tracking property allows it to be applied without wrinkles to levers with uneven surfaces such as those with peeled plating and domed thumb levers. Special processing prevents air bubbles from forming. Before installation, wipe off any dirt or oil on the lever, remove the sticker from the backing paper below, and attach it to the lever. It is also recommended to cut off half of the backing paper only and align it.For curved surfaces, press down slowly and gently on the entire surface from the top.

*This product is designed to be about 0.2mm smaller than the original to ensure a comfortable touch and to prevent peeling.

*This product is covered with a very thin layer of protective film to prevent scratches during transportation. After applying the film, please gently scrape the edges with your fingernail and peel off a piece of the film before use.

1,2,3 lever seal will be encapsulated.

As an added bonus, one oval-shaped seal will be encapsulated.

Use it to protect the thumb lever or  the area where the hand meets the instrument.

*Please check the following compatible models before purchasing.

a: Alexander 103,1103,503,1106 Otto 166,180,201,205 RiccoKuhn 293 Conford 23,28 Durk D10 Lewis&Durk LD-X5 etc 

b: Hanshoyer 801 G10 WenzelMeinl 105 etc. 

c: Hanshoyer 802,4801,6801, WenzelMeinl 205 etc. 

e: Yamaha 567,671,668,871,867,869 etc. 

f: Holton 178,179,180,181,278,279,280,281 etc. 

g: Paxman 20M, etc.