This is a Cobra High Gear HG A1000 CB antenna designed in a cellular style. It is black in color and suitable for use with mobile or in-vehicle radios. It operates within the CB band and is manufactured in China.

HG A1000
"Cellular-Style
Magnet Mount CB Antenna"
For decades Cobra Electronics has been the world's largest-selling and most-respected manufacturer of CB radios. Cobra's unparalleled reputation for quality, innovation and user-friendliness has made it the undisputed #1 choice of professional drivers. Cobra continues its proud tradition of excellence with its revolutionary HighGear® series of CB accessories, designed to provide consumers with a level of performance, features and styling previously unavailable.
The 18-1/2* tall HG A1000 delivers an exceptional combination of convenience and performance.
Its features include:
• 100 watts power handling capability
• Non-corrosive black chrome stainless steel whip and hardware
Non-corrosive black chrome-plated brass components
• Broad-banded frequency range (26-30 MHz)
Works with all CB and 10 meter radios
• Weather channel ready
• Tunable antenna
See instructions below
Matched braided coaxial cable
• Scratch-resistant base pad
HighGear Tips
Antenna Assembly
Loosen the set screw from the top of the antenna mast. Insert the whip into the mast until it touches the bottom. Lightly tighten the set screw.
Anenna mounting
The metal body of your vehicle serves as the ground plane for the antenna. The ideal location for the antenna is on the center of the roof or trunk lid, as far away from any structures like luggage racks as possible. Make sure that all hardware and connections are tightened securely.
Checking The SWR (Standing Wave Ratio)
rea at least 30 feet from any metal objects and
with the doors, hood and trunk closed.
Connect an SWR meter in the coax line betwee
the radio and the antenna (unless your radio has a buit-in SWR meter). Check the SWR on both channel 1 and channel 40. Readings under 2:1 are considered acceptable, with 1.5:1 or lower being desirable.
An SWR reading of over 3:1 on both channel 1 and 40 generally indicates an
n or shorted coax or a poor ground connection
Hechter these coreors
Do not use the radio until the problem has been corrected.
An SWR reading between 2.0 and 3.0 generally indicates a problem with coax quality or length, or an inadequate ground plane.
Tunina the Anienna.
If the SWR on channel 40 is higher than channel 1: Remove the whip from the mast and trim it by 1/8" to 1/4 using a bolt cutter or hacksaw.
Re-insen io me mast, tonen une
set screw and again read the SWR. If the SWR reading is still higher than channel 1, repeat until the two readings are approximately equal. If the SWR on channel 1 is higher
than channel 4u.
Loosen the set screw, pull the whip up 1/4*,
, tighten the set screw and
read the SWR again. If the SWR is still higher than channel 40, repeat until the two readings are approximately equal. Then firmly tighten the set screw.