HOW TO INSTALL LIGHTED RGB EMBLEM
Step 1: Install the Led Lamp file at hand phone through App Store.
Set up Bluetooth with Led Lamp and vehicle.
Step 2: Disconnect vehicle Battery.
Step 3: Remove a Current Grille Logo Emblem. Then prepare surface by removing the remaining glue, grease with paint safe cleaners.
Step 4: Determine the best routing of wires at this time.
⚠WARNING: Consult your vehicle's manual for warranty related information prior to any modification to the factory parts.
Step 5: From the parts supplied in the package identify the Lighted Logo Emblem and mounting hardware kit.
Step 6: Fish the wire through the Grille and route the wiring underneath the car in close proximity to the car's electrical wire loom.
Step 7: Take the ring terminal and prepare the Black (ground) wire of on the emblem harness for ground termination by stripping the 3/8" wire insulation and crimping the Ring terminal, using proper hand crimping tools.
Step 8: Attach ring terminal to the vehicle, uncoated and rustproof point are best for connection by using the sheet metal screws provided.
WIRING COLOR CODES
Black ⮞ Ground
Red ⮞ Running
Step 9: Attach the Red wire from the emblem to: (daytime running lights, fog lights, headlights etc. ) using the wiretap provided.
Step 10: Reconnect the battery
Step 11: Test the Lights for proper operations. Turn your vehicle's on and check the Emblem for proper operation.
Step 13: Secure wires in place by using the provided cable ties.
NOTE: If ANY of your vehicles light functions DO NOT operate with your emblem appropriately, verify all functions with a circuit tester.
IF ALL LIGHT FUNCTIONS WORK PROPERLY, YOU ARE READY TO GO!
Step 14: Peel off the backing off the adhesive tape on the Emblem then position it on the car by applying reasonable force to secure the emblem in place.
** Turn on power and then select the light colour using the led controller **
𝐈𝐌𝐏𝐎𝐑𝐓𝐀𝐍𝐓 𝐒𝐀𝐅𝐄𝐓𝐘 𝐏𝐑𝐄𝐂𝐀𝐔𝐓𝐈𝐎𝐍𝐒
⚠ 𝐖𝐀𝐑𝐍𝐈𝐍𝐆: Do not submerge your Lighted Logo Emblem in water. Doing so may cause damage to the circuitry.
⚠ 𝐖𝐀𝐑𝐍𝐈𝐍𝐆: Check with your current Local and State Rules; Regulations for any additional requirements and limitations prior to installing and using of this product.
𝐏𝐀𝐂𝐊𝐀𝐆𝐄 𝐂𝐎𝐍𝐓𝐄𝐍𝐓𝐒
- Lighted Logo Emblem with Wires
- 3 Cable Ties
- 1 Wire taps
- 1 Ring Terminal
- 1 Butt Splice Connector
- 1 Screw