About this item
|
|
|
|---|---|---|
22AWG solid wireExtension cable contains 17 tinned copper stranded wires and high quality PVC plastic wire sleeve. | Small toolSmall tool can be used to pry open the strip end of the connector, which is more convenient. | Upgraded connectorThe upgraded connector does not distinguish between waterproof and non-waterproof light strips, both are suitable. |
NOTE:
- Make sure your LED light strip is 10mm width 4 pin RGB strip light. It is work for waterproof and non-waterproof led strip lights.
- Ensure your Wire Diameter is within range 20AWG-22AWG /0.34~0.75 mm2 and without stripping wire.
Installation Guides
Strip End
- Ensure your LED light strip is 10mm width and has 4 contacts (+, B, R, G). All contacts are clean and cut the strip straightly.
- Open the transparent cover of connector up to 45 degrees.
- Peel off the 3M tape around the cutting line area on the back of the LED strip, then insert the LED light strip into strip side, with the 4 contacts of the LED strip sitting on the 4 pins of the clasp.
- Close the clasp down with force by pliers.
Wire End
- Cut the desired wire length you need and separated the 4 wires (20-22AWG) around connection part.
- Insert wires into the connector guide slot; Make sure that positive & negative on the strip light surface are corresponding to correct wires.
- Close the transparent cap with a pliers until it is fully seated on both sides of the bottom base. Ensure the metal joint pierces through the wire insulation. (Note: No stripping wires. Positive wire is matched to "+" input power mark on the strip light surface)
Tools Need: A pliers