Set of 5 replaceable Semilac filters for absorbing dust during a manicure. Reusable filters are designed for a 2in1 nail drill without dust with a dust collector.
MAIN FEATURES OF THE FILTERS:
- Filter diameter: 17 cm
- Reusable
- Easy way to clean
- Easy way to change the filter in the Semilac 2in1 No Dust Nail Drill with dust collector.
- Filters are made of non-woven fabric.
FILTER REPLACEMENT
- Make sure the appliance is switched off and then lift the top cover of the hole filter.
- Pull the fabric clip and remove the entire filter.
- Insert a new filter and then replace the filter cover.
IMPORTANT
- Disconnect the power supply when you are not using the cosmetic dust collector.
- If the filter cover is removed without first disconnecting the power, the device will stop working and go into safe mode; The corresponding mode LED will flash. After replacing the filter and replacing the filter cover, the unit will continue to operate.
- The filter is of the replaceable type; should be replaced after 2-3 months of use or immediately in case of damage. For the device to work properly, the filter must be cleaned frequently, preferably after each manicure. After machining the board, remove the accumulated dust, eg by blowing the filter with compressed air or shaking it.
- The filters must not get wet or soaked in anything.