Custom printed 52mm gauge Pod holder for any MK1 Octavia model

Simple and effective, this gauge holder does not block your vents allowing air to move from the vent as it normally would.

Very easy to fit, just pop out the existing fins in your vent and push this in.

All holders are made to ensure a tight fit with the gauge you use, this means that you may need to sand down the inside of the ring to allow your gauge to push in snugly.

 **Please note that this will deform under extreme heat so please exercise caution when you have the heating on full heat as this may cause issues, we would advise blocking off the vent if the heating will be used**

 -----------------------------------

Please note that these are not the same as other cheap gauge holders on eBay, these are custom designed and made in house by myself and other skilled designers.

Any attempts to copy my products, designs or images will be reported and further actions will be taken.