6oz each/12oz x 1
Official  PayPal Seal
 

FITS '79 and up ....XS1100 SPECIALS ONLY 

(no Standard models)

I sell a different petcock for the STANDARDS:  

item # 230844156979


DOES NOT FIT BIKES WITH A STOCK AIRBOX!!!!

LEFT SIDE WILL NOT FIT ON BIKES WITH THE STOCK AIRBOX!!!


Holes are 34mm apart center to center

These use 1/4" fuel line,

(the stock petcock use the next size up, and so do the carbs)

so you will need to use a fuel filter that will accomodate both fuel line sizes.

This petcock is made specifically for the right side,

(I can't find a left side specific new petcock).

but I have found that This Petcock fits both right or left sides,

but note:

The output will point forward on the right side, 

and rearward on the left side.


THIS MEANS LEFT SIDE WILL NOT FIT 

ON BIKES WITH THE STOCK AIRBOX!!!

BUT NO problems, if you are running pods or stacks!

On the Right side, I use an L shaped, 90 degree gas filter near the petcock, to help straighten out the fuel line.  

And I run new fuel line across, from the right side to the left side carb fuel input, and from the left side petcock, to the right side carb input. 

This avoids any kinks and allows you to install fuel filter on both sides. Works great!

You will also be able to get rid of the weird looking 

"Octopus" diaphragm setup-

attached to the carburetors on the left side,

which is a much cleaner look.


THESE ARE Manual Petcocks- no diaphragms,

so you have to manually shut off the fuel when parked!
 

Slightly longer than the stock petcocks,

make sure you have enough clearance to fit.


XS1100SF

XS1100SG

XS1100SH

ALL XS11 MIDNIGHT SPECIALS



YamahaXJ1100Maxim
 1981YamahaXS1100LMidnight Special
 1980YamahaXS1100LMidnight Special
 1981YamahaXS1100SHSpecial
 1980YamahaXS1100SGSpecial
 1979YamahaXS1100SFSpecial

This does NOT fit XS1100 

STANDARD Models

Standards have 46mm 

mounting hole centers 

Please see ebay#  230844156979

 

Fits right and left side ~ 

For XS "SPECIALS"
One petcock per order, fits either side!

Holes are 34mm apart center to center


These petcocks are non-vacuum, manual type,

designed to replace 1979-83 vacuum type.  


Being a non-vacuum petcock means ~

You gotta remember to turn off the gas 

when you park it, people!

Vacuum petcocks are major leakers, 

and are getting to the point of being non-repairable. 
The pot metal/aluminum corrodes on the inside, causing sealing problems,

and eventually the diaphragm ALWAYS eventually fails.....

When the diaphram fails, you wind up with a tank of gas in your crankcase.

~ Which pretty much sucks.

After having spent $$$$ on rebuild kits, only to have my old petcocks still leak,

I don't bother any more. ....Takes too much time, on a gamble that may, or may not work.

I would rather just put new ones on there, and be done with it....     lol    :-)

This Petcock fits to right or left sides, but note that the output will point forward on

the right side, and rearward on the left side.

and each comes with the tap to tank O-Ring seal,


SUPER FAST shipping, and check my 100% feedback,


There is an "ON", "OFF" and "Reserve" position.

remember to turn it OFF!!!!!!!!!


- i am a lightning-fast shipper, and a fellow XS enthusiast!

I will be sending this note after you purchase:

Hello, and thanks for your purchase.

Communication is the most important part of a good ebay experience,

and most sellers truly want to help.  So Ask questions!


First off, this will only fit SPECIAL tanks, NOT STANDARD.

the mounting holes are 34mm apart. Is that what yours are?

Do you have an XS11 Special?

 

just wanted to make sure you read the whole listing. (most people don't... lol)

this part is important: This petcock is made specifically for the right side, 

(I can't seem to find a left side specific, new petcock)

but I have found that This Petcock fits both right or left sides, but note:

The output will point forward on the right side, and rearward on the left side.

THIS MEANS LEFT SIDE WILL NOT FIT ON BIKES WITH THE STOCK AIRBOX!!!


BUT NO problems, if you are running pods or stacks!

these have a 6.5mm output, which is very close to 1/4",
but not a super tight fit, clamps are recommended.

you have to run 1/4" fuel line from the petcock, I usually

put an inline filter between the petcock lines and the carb lines.


Also, these are MANUAL petcocks, which means that you HAVE to turn Both

Petcocks to the OFF position when parked for more than 5 minutes.

Are you good with that? otherwise i will be happy to cancel.

best

steve smith in CA

--------------------------------------------------------------------
ACTUAL EBAY FEEDBACK:

Super fast shipping oh my!!!!!
Buyer:  
 Yamaha XS1100 XS Petcock 
Amazingly fast shipping!! Product as described. Air tight, not a drop of fuel!!Buyer:  
 Yamaha XS1100 XS Petcock XS 1100  46mm
Fits my 81 xs650 special perfectly. fast deal, fast delivery, A+Buyer:  
 Yamaha XS1100 XS Petcock XS 11 


fast shipping, good product!!!!!!!!!!!Buyer:  
  

Great transaction. Exactly what I needed. Buyer:  
  Yamaha XS1100 XS Petcock XS 11 

Item as described, very happy AAA+ Buyer:  
  Yamaha XS1100 XS Petcock XS 11 

Good seller. Very honest and willing to work with you. Buyer:  
  Yamaha XS1100 XS Petcock XS 

very fast shipping would buy from again A+++++ Buyer:  
  Yamaha XS1100 XS Petcock XS 11 

Item was brand new, very happy, no issues to report. Would def use again!!! Buyer:  
  Yamaha XS1100 XS Petcock XS 11  

Great quality. Many thanks! Buyer:  
  Yamaha XS1100 XS Petcock XS 11 

item as described, very happy AAA+ Buyer:  
  Yamaha XS1100 XS Petcock 

A Ohhh Kay!!!!!!!!!!!!           
Buyer:  
  Yamaha XS1100 XS Petcock XS 11 

Recieved Quick!! AAAA++++  
  Yamaha XS1100 XS Petcock XS

Perfect! I love them! Works awesome! Thank you so much! Buyer:  
  Yamaha XS1100 XS Petcock XS 11

Sweet! Exactly what i wanted. Thanks  
  Yamaha XS1100 XS Petcock XS 11
 
 
I

Contact me with any problems.
Please contact me before leaving neutral or negative feedback!
I have a 100% feedback rating !
as always, ask questions first before buying!