This Supply Line Plug with 7/8-in Ballcock threads is used for temporarily sealing end of supply line while the water valve at the wall is shut off. Many of these water valves coming through the wall suppling water to the tend to leak even when they are turned off. To use, first turn off the water Valve located on the wall near the by turning the handle to the right until hand tightened. Next drain the tank by flushing the . Now place a small bucket or bowl under the ’s tank where the water intake is located to catch any water left in the tank after flushing. Next unthread the supply line fitting attached to the fill valve at the bottom of the ’s tank. Now thread into this fitting the red Supply Line Plug to stop any leaking coming from the closed wall valve. Now you are able to the tank and repair or replace the fill valve. Once you’re done with the repairs simply unthread the red Supply Line Plug and thread the end of the line back onto the fill valve at the bottom of the tank hand tight. The Last step is to turn the wall valve back on. RECOMMENDATIONS & LIMITATIONS When repairing fill valves be sure to manufacturer's directions. When turning off and on water valves coming off the wall near the be careful not to pull or torque too hard causing damage to the valve. If the valve breaks or starts leaking water at the connection or wall, you will more than likely need to turn off your homes main water supply coming into the house. (1 Plug Per Bag) (Made in the USA)
7/8" Ballcock Thread – Designed to temporarily seal the end of a supply line.
Stops Leaks During Repairs – Prevents water from leaking when the wall shutoff valve doesn’t fully seal.
Easy Temporary Installation – Simply thread into the supply line while servicing the tank or fill valve.
Made in the USA – Durable plug; 1 plug per bag.