2 used Peco Pl11 surface mounted point motors all checked and working, these are surplus to me as they are from my dismantled N gauge layout. These are very good, I have found the height extenders if you use foam underlay, they make the point higher off the board. I have also found they are best fitted before trying as they tend to jam without the point stopping them from throwing too far. It’s because they are quite powerful little motors. I have included a wiring diagram for those unsure on how to connect them, the damaged point in the photo is a Hornby one just to give an indication they can be used on Hornby too and shows how they fit. Placed next to the point and then attached to baseboard with track pins, saves getting under a baseboard to fit the other type. Check photos carefully as they are the best description but any questions please ask