ready to program TESTED Works 100% Battery installed for OEM Factory
One (1)
Car remote for O.E.M. Original Equipment Manufacturer Factory
remote keyless entry fob alarm controller
Transmitter control clicker keyfob controller replacement clicker beeper keyfab fab
car door opener entry starter vehicle remote start keyfob for FACTORY OEM VEHICLES
| fits OE Part Numbers FCC ID #: fits M3N5WY7777A / MN5WY7777A fits Memory #1or #2 Current Part Number:25926474 fits OE Part Numbers
Replaces
fits OE Part Numbers
Chip; id46 id 46 fits fits 267F-5WY7777A Frequency 315MHz 315 MHz Buttons: 4; Lock Unlock Trunk Release Opener, Panic ALarm Horn See Item Specifications for more details |
| Compatible Vehicle’s 2008 2009 2010 2011 2012 2013 2014 2015 for Cadillac
CTS 2008 2009 for Cadillac XLR |
| Additional Information: Your vehicle must have the factory RKE system on it. Customers are responsible to determine if they have this option and to purchase the correct remote for their vehicle. Also, this remote will work with Memory / Driver #1 or #2 on it indicating the driver memory position. It will work just the same, however, when used it will set the car to the programmed settings select for driver #1 or #2 respectively. Please Note : These vehicles may come with many different remotes. Your remote must look like this one in order for it to work with your vehicle and it must have the same buttons. If you don't have a remote to compare to, simply message us with your VIN # and we will verify the correct remote for your vehicle. |
| Programming Transmitter: Step by Step How to Programming Instructions:
Programming with a Recognized Transmitter
Canadian vehicles require two Recognized Transmitters
IMPORTANT: This procedure is not available when the maximum number of 4 fobs have been programmed. If 4 key fobs are programmed to this RCDLR and this method is attempted, the driver information center (DIC) will display, MAX FOBS LEARNED and the programming procedure will exit.This procedure will add key fobs. Fobs will be numbered in sequence based on when they are programmed; if 2 fobs are currently programmed to the RCDLR, a fob programmed using this method will be numbered as Fob 3. This procedure requires that you have a known good key fob, a replacement key fob, and the vehicle's mechanical key.
1. The vehicle must be off. 2. Both the programmed and the new key fob should be with you. 3. Insert the vehicle key into the key cylinder located on the lower rear fascia on the drivers side of the vehicle. 4. Open trunk. 5. Turn the key five times within five seconds.
6. The DIC will display: READY FOR FOB X (X = fob 2, 3, or 4).
7. Place the new key fob in the glove box key fob pocket with the buttons facing right. 8. A beep will occur and the DIC will display: READY FOR FOB X (X = fob 3 or 4) or MAX FOBS LEARNED. 9. If programming additional key fobs, repeat step 7, or press the OFF/ACC portion of the ignition switch to exit programming mode. 10. Press Unlock on each newly programmed key fob to complete the procedure.Programming without a Recognized Transmitter
Canadian vehicles see Locksmith or dealer
1. The vehicle must be off.
2. Place the new key fob in the glove box key fob pocket with the buttons facing right.
3. Insert the vehicle key into the key cylinder located on the lower rear fascia on the drivers side of the vehicle.
4. Open trunk.
5. Turn the key five times within five seconds.
6. The DIC message will display OFF-ACC TO LEARN.
7. Press ACC on the ignition switch.
8.The DIC will read WAIT 10 MINUTES and counts down to zero.
9. The DIC message will display OFF-ACC TO LEARN again.
10. Press ACC on the ignition switch.
11. Steps8, 9 and 10 will be repeated 2 more times.
12. A beep sounds and the DIC will read READY FOR FOB #1. All previously key fobs have been erased at this time.
13. A beep sounds once programming
is complete. The DIC displays READY FOR FOB #2. To program additional
key fobs take key fob 1 out of the transmitter pocket and place key fob 2
in the transmitter pocket. Up to 4 key fobs can be programmed.The DIC
then displays MAXIMUM NUMBER OF FOBS LEARNED and exits the programming
mode automatically. Press ACC on the ignition switch to complete
process.
14. Press ACC on the ignition switch if programming is complete.
15. Press Unlock on each newly programmed key fob to complete the procedure. |
How to find out if this remote is compatible with your Vehicles’ installed RKE System
If you're not sure your vehicle can use this remote, please ask questions or contact your local dealer first.
1. Check the back of your current or old keyless remote to match FCC ID /Part #’s.
2. Contact your local dealer and tell them your VIN# and ask what part # / FCC ID you need.
Your vehicle will be installed with one of the following keyless entry systems:
a. Standard Keyless Remote Packages: Installed at time of manufacture.
b. Optional Keyless Remote Packages: Installed by a dealer.
c. Aftermarket Keyless Remote Packages: Installed by previous owner or a car/audio shop.
d. No remote keyless entry system at all.
100% Guarantee Remote Shipping / Return Policy
Warranty/Returns:
1. We have a 30 day return policy.
2. All returns for replacements and refund need an RMA #.
3. Please contact us before returning items so we can give you the RMA # and the proper return address.
4. No refunds / replacements will be granted without an RMA#
5. All cut keys are subject to a $20 deduction from the refund
We ensure proper working condition of all previously used or new remotes through a serious of tests performed with the Santronics Testing device. Each button is tested for functionality prior to shipment and then logged.
Please Note: Each remote and circuit board is UV ID’d prior to shipment – All returns receive a UV ID inspection to verify originality of remote sent prior to refund or replacement.
Does this keyless remote entry come with a battery?
Yes. It will have a working battery installed.
Battery Condition:
A. All remotes sold on Keyless4u include working batteries.
B. Installed batteries are not tested for battery life- they are simply working.
Some are new and some are used.