A lightweight model weighing only 160 g, which is 35% lighter than conventional models.
Its compact size ensures it does not interfere when attached directly to the spray gun handle.
Although it is a regulator, it has been miniaturized to the same size as commonly available air flow controllers on the market.
By installing the regulator at the spray gun handle, stable painting can be achieved with constant pressure and air consumption, without being affected by pressure fluctuations (approximately 0.2 MPa) between the compressor’s ON/OFF load cycles.
Even when using a transformer (air source unit), if multiple air devices are connected to a single transformer, pressure and air consumption may fluctuate due to the ON/OFF operation of other devices, resulting in unstable painting conditions. However, by using a hand-held regulator, painting can be performed with consistent pressure and air consumption.
Operating Pressure: 0–0.7 MPa
Applicable Fluid: Air
Connection Port Size: G1/4
Dimensions: W66 mm × D75 mm × H62 mm
Compatible Spray Guns: FINER, FINER2, F110-P, F21L-P, F21-P, F210-P, etc.
Weight: 160 g