FCC ID: GOH-PCMINI-4Q

Interchangeable FCC IDs

 Interchangeable Part #s

Interchangeable circuit board #s: 

 Frequency: 433 – 434 MHz

 LED color: Red

 1 button

 Battery: (2) CR 1220

Compatible with the following systems:

APS900

APS901

APS901C

APS901N

AS9055C

AS9055T

AS9233ST

JKRS1

JKRS1T

PRO9051N

CA421

CA420A

CA420

CA440TW

CA440SS

Programming Instructions:

METHOD #1

NOTE: All applications require that tach be programmed.

The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start without first programming tach, the unit will flash the parking lights 7 times indicating tach has not been learned and stored.

If the tach rate is not properly programmed to the specific vehicle, the unit may not realize that the vehicle is running in certain instances and could re-engage the starter motor.

The Remote Car Starter will learn the tach rate of most vehicles single ignition coils, multiple coil packs, and or single injector.

TO LEARN TACH:

1. Turn the ignition key to the ON position.

2. Press and release the program push-button switch 3 times.

3. Immediately turn the ignition key OFF.

4. Hold the program push-button switch ON, then start the vehicle using the ignition key.

5. When the unit senses the tach signal, the parking lights will begin to flash.

6. Release the program push-button switch. The parking lights will turn on for 3 seconds to indicate that the tach signal is stored and the unit is now out of the program mode.

METHOD #2

1. Turn the ignition to the on position.
2. Press and release the programming switch 3 times.
3. Press and hold, for 3 seconds, the button of the transmitter you wish to add until the parking light flashes, indicating the transmitter has been learned.

Repeat step 3 for up to a total of 4 transmitters.

Note: Do not allow more than 15 seconds to lapse between steps or the program mode will be automatically exited and you will have to start over.