The SDS011 using principle of laser scattering,can get the particle concentration between 0.3 to 10um in the air.It with digital output and built-in fan is stable and reliable.
Characteristics:
1. Accurate and Reliable: laser detection, stable, good consistency;2. Quick response: response time is less than 10 seconds when the scene changes;3. Easy integration: UART output (or IO output can be customized), fan built-in;4. High resolution: resolution of 0.3ug/m3.
Scope of application:
PM2.5 DetectorPurifierAir ExchangersFiltering system
Working principle:
Using laser scattering principle:Light scattering can be induced when particles go through the detecting area.The scattered light is transformed into electrical signals and these signals will be amplified and processed.The number and diameter of particles can be obtained by analysis because the signal waveform has certain relations with the particles diameter.
Technical Parameters: No. Item Parameter1 Measuring output PM2.5,PM102 Range 0.0-999.9 ug/m33 Power supply voltage 5V4 Maximum working current 100mA5 Sleep current 2 mA6 Operating temperature range -20-50℃7 Response time 1s8 Serial data output frequency 1 time/s9 Particle diameter resolution Less than 0.3um10 Relative error 10 Product size 71x70x23mm Interface specification:
Pin Name explain1 CTL Control pin, reserved2 1um >0.3 Micron particle concentration, PWM Output3 5V 5V power input4 25um >2.5 Micron particle concentration, PWM Output5 GND GND6 R Serial port receiver RX7 T Serial port transmission TXPS: The pitch of Interface is 2.54mm
Communication protocol:
Serial communication protocol: 9600 8N1. (Rate of 9600, data bits 8, parity none, stop bits 1)Serial report communication cycle: 1+0.5 secondsData frame (10 bytes): message header + order+ data(6 bytes) + checksum + message trailer
The number of bytes Name Content0 message header AA1 order C02 data 1 PM2.5 low byte3 data 2 PM2.5 high byte4 data 3 PM10 low byte5 data 4 PM10 high byte6 data 5 0(reserved)7 data 6 0(reserved)8 checksum checksum9 message trailer ABChecksum: data 1 + data 2 + ...+ data 6PM2.5 data content: PM2.5 (ug/m3) = ((PM2.5 high byte*256 ) + PM2.5 low byte)/10PM10 data content: PM10 (ug/m3) = ((PM10 high byte*256 ) + PM10 low byte)/10
Package included:
1PCS PM2.5 Air particle dust sensor SDS011 module laser inside digital output