Features:
- 100% Brand New and High Quality
- output interface: WG26/34,RS485,RS232 optional
- Read rate<0.2s
- Read interval<0.5s
- Operating distance: 1-5cm
- Support card: MIFARE Classic® card/tk4100/em4100/em4200
- Frequency:13.56MHZ and 125khz
- With inside antenna
- With inside buzzer
- Power supply: DC 9V-13V->Standard voltage 12V
- Operating current:70mA
- Data Transferring Distance: 100 meters
- Size：46mmx15mm
Wire instructions：
WG26/34：
- red-DC12V
- black-GND
- green-D0
- White-D1
- blue- Ungrounded, output is WG26, grounded, output is WG34
RS485：
- red-DC12V
- black-GND
- green-485+
- White-485+
RS232：
- red-DC12V
- black-GND
- green-TXD
Installation Instructions：
1. Stick the sticker in the card reader box to the location where the card reader is to be installed, open two positioning holes and a middle outlet hole according to the marked position, and plug the positioning holes with rubber plugs (Note: If installed on the wall, concealed installation requires pre-buried 86 installation boxes)
2. Use a cross screwdriver to unscrew the screws that fix the panel and the base plate, remove the base plate, and use screws to fix the base plate to the wall on the control entrance and exit side.
3. Pass the card reader's wire through the outlet hole, connect the wire according to the instructions, and fix the screws of the card reader panel and the base plate.
Package：
1 x rfid reader