Sold individually, not in "sets".
To find the size you need. simply measure the BLUE area of your factory grill and tailgate/rear hatch/trunk emblems. It is important to confirm the size you need, especially if you purchased your vehicle used, as sometimes the previous owner has swapped out the emblems, grills or entire tailgates for one from a different year. See below info for help in sizing:
Steering wheels (most ALL years/models, but measure to confirm) = .875in x 2.25in
-1999-2004 Super Duty GRILL emblems = 2.375in x 6.3in
-2005-2010 Super Duty GRILL emblems = 3.2in x 8.2in
-2011-2016 Super Duty GRILL emblems = 4.56in x 12in
-2017+ Super Duty GRILL and TAILGATE emblems = 4.125in x 10.875in (NOTE: Platinum and King Ranch require 4.625in Tailgate overlay)
-1999-2004 Super Duty TAILGATE emblems = 2in x 5in
-2005-2016 Super Duty TAILGATE emblems = 3.2in x 8.2in
**NOTE: if your vehicle has the factory back-up camera inside the
rear emblem, you will need a 2.375in x 6.3in size overlay. Measure to
confirm!**
The sizes in the drop-down menus may fit many other models as well...just measure the BLUE area to find out!
DOMED with a thick layer of clear polyurethane, these are self-adhesive, flexible, vinyl *OVERLAYS* that are designed to install over your factory Ford emblems- the factory emblems are NOT included- sorry!
How hard are these to install? Not hard at ALL! Why? Because this very high-tech, specialty vinyl allows you to position the overlay and then lift it back up if you need to- again and again and again until you apply pressure and make it "permanent"! Install them DRY with no worries!! When you want to remove it- simply heat it up (hair dryer works fine if you do not have a heat gun) and peel it off. AND it's removable up to 4yrs without leaving any residue or adhesive behind!
From the manufacturer:
"Durable, dimensionally stable, vinyl film with positionable,
pressure activated adhesive (permanent, changeable
or removable) that allows it to be repositioned on the application surface
during installation. Special channels allow
trapped air to escape, which reduces air bubbles that typically occur as
large format graphics are installed."
We don't just throw
these decals in an envelope and slap a stamp on them!! They will
be sandwiched between two layers of thick Coroplast®- these babies
won't show up damaged!!