



basic skills | VICTOR 9000E | VICTOR 9000F | |
Model distinction | Fork type (which can be switched from different angles) | Check type (switching from different angles) | |
Features | High-voltage AC current measurement, low-voltage AC current, online AC current monitoring | ||
power supply | DC6V alkaline dry battery (1.5V AAA×4) | ||
test method | Non-contact U-CT | ||
transfer method | 433MHz wireless transmission, the transmission distance is about 100 meters | ||
Display mode | 4-digit LCD display, backlight function, suitable for dim places | ||
LCD size | 47mm×28.5mm | ||
Instrument size | Tester: 107mm × H 252mm × thick 31mm; Receiver: 78mm × H 212mm × thick 41mm | Tester: Wide 210mm × Hight 246mm × thick 45mm; Receiver: Width 78mm × Hight 212mm × thick 41mm | |
Jaw size | φ68mm | φ128mm | |
Insulating rod size | φ45mm, closed state 1150mm, extended state about 4500mm. | ||
Insulating rod voltage level | 110KV | ||
Sampling rate | 2 times/sec | ||
Measuring range | 0.00A~9999A (50/60Hz automatic) | ||
Resolution | 0.01A | ||
Change files | 0.00A~9999A fully automatic gear shift | ||
Test accuracy | ±2%±5dgt (The wire is located near the center of the bottom end of the U-shaped jaw, 23℃±2℃) | ||
Position error | The wire under test should be as close as possible to the center of the bottom end of the U-shaped jaw | ||
data storage | 99 groups, the "MEM" symbol indicates during the storage process, and the flashing display of the "FULL" symbol indicates that the storage is full | ||
Line voltage | Test of bare wires below 60kV (operation with insulating rod, fully extended telescopic insulating rod) | ||
Data retention | In the normal test mode, press the HOLD key to keep the data, the "HOLD" symbol is displayed, and then press the HOLD key to cancel | ||
Data access | The "MR" symbol indicates that the stored data can be flipped up and down | ||
Overflow display | Over-range overflow function: "OL A" symbol display | ||
No signal indication | When the receiver does not receive the transmitted signal, the "no- -" symbol is displayed dynamically | ||
Automatic shut-down | About 15 minutes after power on, the meter will automatically shut down to reduce battery consumption | ||
Instrument quality | Detector: 235g (including battery), receiver: 280g (including battery, total mass of the meter: 2300g (including insulating rod and battery) | ||
Working temperature and humidity | -10℃~40℃; below 80%Rh | ||
Interference | Try to avoid 315MHz, 433MHz co-frequency signal interference | ||
Dielectric strength | AC 220kV/rms (the telescopic insulating rod is fully opened, between the two ends) | ||
Random accessories | Clamp meter: 1 piece; receiver: 1 piece; telescopic insulating rod: 1 piece; battery LR03: 8 pieces; cloth bag: 1 piece | ||
