1. If the engine is failure to start normally under the normal ignition and cylinder compression, it is likely that the carburetor needle will need to be adjusted.
2. After tightening the main oil needle on the carburetor, loosen 1/4 turn and start the flywheel to make the mixture ratio of gasoline and air reach the normal working mixture ratio after several times.
3. When the machine stops running, turn off the power switch.
How to Start This IC Engine:
Step 1. Check the engine and wire from the board to connect the tank line, then install 3 AA batteries (4.5V).
Step 2. Add gasoline (95#) to the tank. After filling, turn the flywheel on the right side of the engine, which allows the mixed fuel to enter the cylinder to ensure that there are no empty tubes inside.
Step 3. Turn on the power and quickly turn the flywheel on the right side to start the engine.
Step 4. During startup, gently cover the inlet with your hand and release it instantly a few times to allow the machine to suck in fuel smoothly. This step is not required after a normal startup!
Specif